Total: $0.00
SR-6 Helical Rotor Solar Pump

SR-6 Helical Rotor Solar Pump


The SR-6 helical rotor submersible water pump offers a slightly greater water pumping depth than our SR-4 model.

All SunRotor pumps require a SunRotor DC Input Controller to operate properly. Attempting to run our pumps with any other controllers can result in pump failure and will void the warranty on the pump.

• Nominal 48 volt operation
• Usable voltage range 24-48 volts
• Power range 390 watts to 780 watts
• Solar, battery or a combination
• Maximum functional lift capability of 200 ft (61 m)
• Max flow at 100 ft (30 m) is 6 gallons/min (22.71 liters/ min)
• Highly reliable, single moving part progressive cavity technology
• Readily repairable in the field
• 3/4 inch FNPT output
• Designed for submersible operation up to 100 ft
• 3 inch diameter (76 mm) fits 3.5 inch (89 mm) casing
• Light weight - 12 pounds (5.4 kg)
• Submersion limit of 100 ft below static water level (ex: 100 ft submersion + 50 ft static water level: 150 ft)
• Brushless DC motor technology avoids conventional DC brush maintenance and replacement
• All electronics are mounted above ground for longer life and easy access
• Entire pump body is stainless steel to comply with all local code and pump installation requirements
• CE certified
• ISO 9001

SunRotor Submersible Pump Diagram

  1. PV Panel Array
  2. Solar Module Mounting Rack
  3. Water Pipe
  4. Well Seal Assembly
  5. Low Water Sensor
  6. Submersible Pump
  7. Conduit and Wiring Harness from Controller to Well Seal
  8. Wiring Harness from Controller to Solar Modules
  9. DC Input Controller
  10. Tank Full Tethered Float Switch and Weight
  11. Anti-freeze Bleeder Valve
  12. Check Valve

If you need assistance in sizing a solar power system, you can download our solar power pumping system sizing guide, click here to request a quote, or contact us at 1-866-246-7652 and let one of our sales representatives design a custom system to meet your water pumping needs.